HELP! I have properly burned a dreamshell rc1 but doesn't work with my dreamcast NTSC-J console! Also, I have problems with the sd mod to serial pinout, where should i solder the ground in the dreamcast? Your help would be of great help!
Sir SWAT I need your help badly please....
please thank you very much!
(14.03.2013 09:57)SWAT писал(а): [ -> ]Try first beta 4.
"sir swat thanks for the advice...please pardon me but I still have to more questions if you dont mind:
1. in the sd card serial pinout, where will I solder the ground? is it in the dreamcast motherboard or somewhere else?
2. if I use the sd form dshell beta 4 cd,will it load the dshell sd form rc 1 in the card reader?
thanks in advance for the answer!
1. Any ground on the motherboard.
2. It makes no sense. If RC1 does not work, then you will only replace by a jumper the resistor RA601 from the motherboard for fixing this. Or connect direct to test points before resistor
http://yam.20to4.net/dreamcast/va1.html
hello swat! in some Japanese dreamcast not boot dreamshell, why can this be?
not read the disc, the dreamshell cd copy, read only original CDs, not read copys
only BIOS mod. Bios need flash on programmator or another console
Your DC with disabled Mil-cd in BIOS? What a revision of motherboard?