DC-SWAT Forum

so is the connection?

MX29LV160 it's a 3.3V chip, VA0 have 5V logic. Theoretically you can't use this chip on VA0, but it's works in some cases. So it's not guaranteed.
You can try use another chip, RC2/3 supports more chips but it's not fully tested, just supported by datasheet. Look for chip compability list here http://www.dc-swat.ru/page/dreamshell/firmware/ or direct in bflash module code https://github.com/DC-SWAT/DreamShell/bl...ces.c?ts=4

(29.01.2015 09:41)SWAT писал(а): [ -> ]MX29LV160 it's a 3.3V chip, VA0 have 5V logic. Theoretically you can't use this chip on VA0, but it's works in some cases. So it's not guaranteed.
You can try use another chip, RC2/3 supports more chips but it's not fully tested, just supported by datasheet. Look for chip compability list here http://www.dc-swat.ru/page/dreamshell/firmware/ or direct in bflash module code https://github.com/DC-SWAT/DreamShell/bl...ces.c?ts=4

You are lucky If you used MX29LV160 on VA0.