I have a problem with mod.IDE to my dream. I think the connections are welded well, because he says that identifies a device. the problem and who do not want to recognize, but do not understand the problem.
Post a picture of the starting dreamshell to better understand the problem.
Thank you for the answer.
Are you pretty sure that you soldered every wire in the correct points?
Post some pics of your mod, please.
Thank you for the reply. I enclose a photo, I hope to see well.
It seems fine as far I can see.
But I could not see where the end of the wires are connected to. Did you wired them to an IDE connector? Are you using some SATA adapter? More details.
What IDE devce? Try another and without *smart* adapters.
you, use an SD adapter, I just purchased a hd that arrives in a few days.
It is the version with 44 pins with hd 2.5
sure? so with a true hd I solve my problem.
I update the discussion, just get me the hard drive
SD2IDE don't work with dreamcast
I hope with all my heart is that the problem
Thanks for all the answers
Problem with that adapter is because there is no jumper to change to SLAVE mode.
(21.03.2017 18:05)megavolt85 писал(а): [ -> ]SD2IDE don't work with dreamcast
Some works, some not.
Arrived now the hard disk, do not boot from HD, and even from sd.
you use 80 wire ide cable?
No, of course not. 44 wires
gd-rom is installed, and the console is assembled.
i look on photo error when driver set DMA mode
need photo your G1ATA mod
Now I do not have on hand, I can just upgrade to photograph the area G1ATA
Did you wired the pin 44 to Ground? If not, do it, pin 44 must be in low state.