ISO Loader 0.7.x Beta

[MastaG]

I'm having problems with my CF reader.
My GD-ROM drive is equipped with the IDE quick solder board from here: https://dragoncity17.wordpress.com/2018/...st-gd-ide/

I have two CF-readers.
The one first uses a regular 40-pin IDE cable and FDD-power plug for 5v.

This one works great with both 40 and 80 conductor IDE cable, even very long IDE cables work fine.
I just have to solder a 5v wire to the FDD-pin and I can play for hours without problems.
Happy times

However this CF reader is too big to fit on top of the modem (I've made an internal slot for CF).
So I bought a smaller CF:
SEE HERE: https://pasteboard.co/IYiKUVd.jpg

As you can see I cut off the IDE connector at one side (the other one fits in the dragon17 GD-IDE).
And I split the wires and soldered all 40 of them.

But it's not working very well...
Sometimes Error 5 trying to mount FAT-FS.
Sometimes error d1 error reading sector blah.

I've tested all 40 points with the GD-IDE (it has numbers written on it).. and all are connecting fine.

Any ideas?