ISO Loader 0.8.x Beta + preview of DreamShell v4.0 RC 5

[MastaG]

(02.05.2023 00:03)fafadou писал(а):  I'm not at home and I didn't have time to try this new fabulous update. Unfortunately I'll come back in one week.

Just trying quickly again sega rally 2 PAL but still back screen, but the config is sync 0x8cf80000 for RC4, the issue is not the loader.



I have a problem with my compact Flash adapter : the pins have not the same size as my ide cable connector :
https://ibb.co/k0ykhJw


what could you suggest to me please ? Is there any adapter ?

That's correct, you bought 44-pin CF reader.
44-pin P-ATA uses the same pinout as regular 40-pin IDE.
Only the difference is that the pins are a little smaller.
Also you need to provide 5V to pin 41 and 42 (this will power your CF card) and connect extra ground to pin 43.
Pins 1 to 40 are the same.
See the schematic: https://www.unitechelectronics.com/ide44pinout.gif

The best thing you should do is desolder the pin-header then just solder all 40 wires straight onto the pads.
Also solder extra 5V wires to pad 41 and 42 and extra ground to pad 43.

Because 44-pin P-ATA is smaller, you can easily fit the reader inside the case (on top of modem housing)

Or if you do not want to solder.
https://a.aliexpress.com/_EHcXDID
(Make sure you insert the cable the correct way)