DC-SWAT Forum

(29.04.2018 02:10)dragoncity писал(а): [ -> ]I don't understand what is the problem exactly?

Voltage with Respect to Ground
VCC (Note 1) . . . . . . . . . . . . . . . . . -0.5 V to +4.0 V

on VA0 board VCC +5 V

Ok I put 3.3v since IC302 Pin1 it's more secure

(27.04.2018 23:19)dragoncity писал(а): [ -> ]Ok I try with Region Changer 1.5 > Backup Flash...but doesn't work...

I just put a SD...need HDD?

How do you want the dump?

I used Region Changer 1.85 > Backup Flash > Create... progress green bar full...nothing saved in SD nor HDD something wrong with the app?

if use bios flasher > option > what values should I put? 0 and 0 and nothing happened...

my board is VA1

bios flasher used only for read/write bios rom

for change region check this software

(30.06.2018 13:49)megavolt85 писал(а): [ -> ]bios flasher used only for read/write bios rom

for change region check this software

finally I found only Region Changer 1.5 (boot from CD only, no app version) > Backup Flash > Create ...the flash bin was saved in VMU ....Region Changer 1.85 > Backup Flash in RC4 app versions did not work!

attached my region changed PAL to JAP system FLASHBKP.BIN, please if you can give some ideas to my thread in "FIX Games Work in SD+CDDA and NOT in IDE+CDDA" Post#8 http://www.dc-swat.ru/forum/thread-3120.html

tried to RESTORE flash bin (create from real JAP console un-modded) to this region changed PAL to JAP system

Region Changer 1.5 > Backup Flash > Restore

compare the restored FLASH BIN, no change!!! Same FLASHBKP.BIN as above in post#65

Question: need to apply +12V to R512? or just because Backup Flash > Restore did not work?

+12V to R512 need only for restore

after I used Region Changer > Change Region > Write, I did not press "Reboot" but instead Exit > [X], and then switched-off the console, switched-on again a few seconds...

everything looked fine, and used Region Changer again, region had changed...

question: is it ok without using button "Reboot"? will some codes not correct?

Thank you!!

It's ok. The button "Rebooot" just for convenience.